Skip navigation

Experimental and modelling analysis on the performance of anisotropic conductive films as used in electronics packaging

Experimental and modelling analysis on the performance of anisotropic conductive films as used in electronics packaging

Yin, Chunyan (2006) Experimental and modelling analysis on the performance of anisotropic conductive films as used in electronics packaging. PhD thesis, University of Greenwich.

[img]
Preview
PDF (Pages containing signatures redacted)
Chunyan Yin 2006 - Redacted.pdf - Published Version
Available under License Creative Commons Attribution Non-commercial No Derivatives.

Download (33MB) | Preview

Abstract

The aim of this research is to understand the failure modes and mechanisms of adhesive materials used to flip-chip bond a silicon die onto a polyimide substrate. The bonding material investigated in this research is called Anisotropic Conductive Film (ACF). This is a promising interconnection material and has gained extensive interest in the electronics packaging industry.

Both the experimental and finite element analysis (FEA) methods were used in order to investigate the behaviour of the ACF materials when subjected to certain manufacturing and environmental testing conditions. The manufacturing condition investigated was a subsequent solder reflow process on an ACF flip-chip bonded device. The environmental testing condition investigated was the moisture test.

For the manufacturing condition, both experimental and modelling results demonstrate the impact of a subsequent reflow process on the behaviour of the ACF joint. Typical failures observed after this process were cracks at the pad/particle interface. This failure mode was more sever with a higher peak reflow temperature. This was also found using FEA where high tensile stresses were predicted in these regions. FEA modelling was also used to help identify the mechanisms leading to these failures. This is primarily due to the Coefficient of Thermal Expansion (CTE) miss-match in the materials and the elastic/plastic deformation behaviour of the conductive particle. Important design variables that can minimise these failures are the Young’s Modulus and CTE of the adhesive and the height of the hump on the die.

For the environmental testing condition, an autoclave test at 121°C, 100%RH and pressure of 2atm was used. More than 85% of the ACF joints failed during the first 24 hours of testing. The failure mode observed was cracking along the interface between the adhesive and substrate and pad. A macro-micro modelling approach was used to help identify the mechanisms leading to these failures. It was found that most of the damage is caused by moisture diffusion and associated swelling. Important design variables that will help minimise this mode of failure are: Coefficient of Moisture Expansion (CME) and Young’s Modulus of the adhesive and the height of the bump on the die.

Item Type: Thesis (PhD)
Additional Information: uk.bl.ethos.437710
Uncontrolled Keywords: anisotropic conductive film, ACF, mathematical modelling, modelling analysis, finite element analysis, FEA, electronics, manufactures, technology
Subjects: Q Science > QA Mathematics
T Technology > TS Manufactures
Pre-2014 Departments: School of Computing & Mathematical Sciences
School of Computing & Mathematical Sciences > Centre for Numerical Modelling & Process Analysis
Last Modified: 16 Feb 2017 12:40
Selected for GREAT 2016: None
Selected for GREAT 2017: None
Selected for GREAT 2018: None
URI: http://gala.gre.ac.uk/id/eprint/6355

Actions (login required)

View Item View Item

Downloads

Downloads per month over past year

View more statistics